Dell PowerEdge M805 - Manual (Page 474)

466 Spanning Tree Commands
www
.dell.com | support.dell.com
Example
The following example configures the spanning-tree cost on 1/g5 to 35000.
console(config)#interface ethernet 1/g5
console(config-if-1/g5)#spanning-tree cost 35000
spanning-tree disable
Use the spanning-tree disable command in Interface Configuration mode to disable spanning-tree
on a specific port. To enable spanning-tree on a port, use the no form of this command.
Syntax
spanning-tree disable
no spanning-tree disable
Default Configuration
By default, all ports are enabled for spanning-tree.
Command Mode
Interface Configuration (Ethernet, Port-Channel) mode
User Guidelines
This command has no user guidelines.
Example
The following example disables spanning-tree on 1/g5.
console(config)#interface ethernet 1/g5
console(config-if-1/g5)#spanning-tree disable
spanning-tree forward-time
Use the spanning-tree forward-time command in Global Configuration mode to configure the
spanning-tree bridge forward time, which is the amount of time a port remains in the listening and
learning states before entering the forwarding state.
To reset the default forward time, use the no form of this command.
Syntax
spanning-tree forward-time seconds
no spanning-tree forward-time
• s econds—Time in seconds. (Range: 4 - 30)