Dell PowerEdge M805 - Manual (Page 205)

GVRP Commands 175
Syntax
gvrp enable
no gvrp enable
Default Configuration
GVRP is globally disabled.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example globally enables GVRP on the device.
console(config)#gvrp enable
gvrp enable (interface)
Use the gvrp enable command in Interface Configuration mode to enable GVRP on an interface.
To disable GVRP on an interface, use the no form of this command.
Syntax
gvrp enable
no gvrp enable
Default Configuration
GVRP is disabled on all interfaces by default.
Command Mode
Interface Configuration (Ethernet, Port-Channel) mode
User Guidelines
An Access port cannot join dynamically to a VLAN because it is always a member of only one
VLAN.
Membership in untagged VLAN would be propagated in a same way as a tagged VLAN. In
such cases it is the administrator’s responsibility to set the PVID to be the untagged VLAN
VID.