Dell PowerEdge M805 - Manual (Page 726)

732 OSPFv3 Commands
www
.dell.com | support.dell.com
enable
Use the enable command in Router OSPFv3 Configuration mode to enable administrative mode
of OSPF in the router (active).
Syntax
enable
no enable
Default Configuration
Enabled is the default state.
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example enables administrative mode of OSPF in the router (active).
console(config)#ipv6 router ospf
console(config-rtr)#enable
exit-overflow-interval
Use the exit-overflow-interval command in Router OSPFv3 Configuration mode to configure the
exit overflow interval for OSPF. It describes the number of seconds after entering Overflow state
that a router will wait before attempting to leave the Overflow State. This allows the router to
originate non-default AS-external-LSAs again. When set to 0, the router will not leave Overflow
State until restarted.
Syntax
exit-overflow-interval seconds
no exit-overflow-interval
• seconds—Exit overflow interval for OSPF (Range: 0-2147483647)
Default Configuration
0 is the default value for seconds.