Dell PowerEdge M805 - Manual (Page 683)

OSPF Commands 689
no distribute-list accesslistname out {rip|static \ connected}
• accesslistname—The name used to identify an existing ACL. The range is 1-31
characters.
• rip—Apply the specified access list when RIP is the source protocol.
• static—Apply the specified access list when packets come through the static route.
• connected—Apply the specified access list when packets come from a directly connected
route.
Default Configuration
This command has no default configuration.
Command Mode
Router OSPF Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example specifies the access list to filter routes received from the RIP source
protocol.
console(config-router)#distribute-list ACL40 out rip
enable
Use the enable command in Router OSPF Configuration mode to reset the default administrative
mode of OSPF in the router (active). Use the no form of the command to disable the
administrative mode for OSPF.
Syntax
enable
no enable
Default Configuration
Enabled is the default configuration.
Command Mode
Router OSPF Configuration mode
User Guidelines
This command has no user guidelines.