Dell PowerEdge M805 - Manual (Page 634)

638 IPv6 Routing Commands
www
.dell.com | support.dell.com
Syntax
ipv6 nd ra-lifetime seconds
no ipv6 nd ra-lifetime
• seconds—Lifetime duration. The value must be zero, or it must be an integer between
the value of the router advertisement transmission interval and 9000 seconds. A value of
zero means this router is not to be used as the default router. (Range: 0-9000)
Default Configuration
1800 is the default value for seconds.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets at 1000 seconds the value that is placed in the Router Lifetime
field of the router advertisements.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 nd ra-lifetime 1000
ipv6 nd reachable-time
Use the ipv6 nd reachable-time command in Interface Configuration mode to set the router
advertisement time to consider a neighbor reachable after neighbor discovery confirmation.
Syntax
ipv6 nd reachable-time milliseconds
no ipv6 nd reachable-time
• milliseconds—Reachable-time duration. A value of zero means the time is unspecified by
the router. (Range: 0-3600000 milliseconds)
Default Configuration
The default value for neighbor discovery reachable times is 0 milliseconds.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode