Dell PowerEdge M805 - Manual (Page 216)

186 IGMP Snooping Commands
www
.dell.com | support.dell.com
• time-out—mrouter timeout in seconds for IGMP. (Range: 1 - 2147483647)
Default Configuration
The default value is 300 seconds.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the mrouter timeout to 200 seconds.
console(config-if-1/g1)#ip igmp snooping mrouter-time-out 200
show ip igmp snooping groups
Use the show ip igmp snooping groups command in User EXEC mode to display the Multicast
groups learned by IGMP snooping.
Syntax
show ip igmp snooping groups [vlan vlan-id] [address ip-multicast-address]
• vlan_id—Specifies a VLAN ID value.
• ip-multicast-address—Specifies an IP Multicast address.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
To see the full Multicast address table (including static addresses) use the show bridge
address-table command.
Example
The example shows Multicast groups learned by IGMP snooping for all VLANs.
console>show ip igmp snooping groups
Vlan IP Address Ports
---- ----------- -------