Dell PowerEdge M805 - Manual (Page 733)

OSPFv3 Commands 739
Default Configuration
1, the highest router priority, is the default value.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets the OSPF priority at 50 for VLAN 15.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf priority 50
ipv6 ospf retransmit-interval
Use the ipv6 ospf retransmit-interval command in Interface Configuration mode to set the OSPF
retransmit interval for the specified interface.
Syntax
ipv6 ospf retransmit-interval seconds
no ipv6 ospf retransmit-interval
• seconds—The number of seconds between link-state advertisement retransmissions for
adjacencies belonging to this router interface. This value is also used when retransmitting
database description and link-state request packets. (Range: 0 to 3600 seconds)
Default Configuration
5 seconds is the default value.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets the OSPF retransmit interval at 100 seconds.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf retransmit-interval 100