Tunnel source – Dell PowerEdge M805 User Manual
Page 796
Advertising
806
Tunnel Interface Commands
www
.dell.com | support.dell.com
tunnel source
Use the tunnel source command in Interface Configuration mode to specify the source transport
address of the tunnel, either explicitly or by reference to an interface.
Syntax
tunnel source {ipv4addr | vlan vlan-id}
no tunnel source
•
ipv4addr—Valid ipv4 address.
•
vlan-id—Valid VLAN ID.
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Tunnel) mode
User Guidelines
This command has no user guidelines.
Example
The following example specifies VLAN 11 as the source transport address of the tunnel.
console(config)#interface tunnel 1
console(config-if-tunnel1)#tunnel source vlan 11
Advertising