Dell PowerEdge M805 - Manual (Page 273)

System Management Commands 251
Command Mode
Stack Global Configuration
User Guidelines
The switch index can be obtained by executing the show supported switchtype command in
User Exec mode.
Example
The following example displays how to add to stack switch number 2 with index 1.
console(config)# stack
console(config-stack)# member 2 1
movemanagement
Use the movemanagement command in Global Configuration mode to move the Management
Switch functionality from one switch to another.
Syntax
movemanagement fromunit tounit
• fromunit—The switch identifier on the current Management Switch.
• tounit—The switch identifier on the new Management Switch.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
Upon execution, the entire stack, including all interfaces in the stack, are unconfigured and
reconfigured with the configuration on the new Management Switch.
After the reload is complete, all stack management capability must be performed on the new
Management Switch.
To preserve the current configuration across a stack move, execute the copy configuration
command before performing the stack move. A stack move causes all routes and layer 2
addresses to be lost. This command is executed on the Management Switch. The
administrator is prompted to confirm the management move.