Dell PowerEdge M805 - Manual (Page 519)

VLAN Commands 515
Default Configuration
This command has no default configuration.
Command Mode
VLAN Database mode
User Guidelines
This command has no user guidelines.
Example
The following example displays how to attach the VLAN ID "100" to the protocol-based
VLAN group "3."
console#vlan database
console(config-vlan)#protocol group 3 100
protocol vlan group
Use the protocol vlan group command in Interface Configuration mode to add the physical
unit/port interface to the protocol-based group identified by groupid. A group may have more than
one interface associated with it. Each interface and protocol combination can be associated with
one group only. If adding an interface to a group causes any conflicts with protocols currently
associated with the group, this command fails and the interface(s) are not added to the group.
Ensure that the referenced VLAN is created prior to the creation of the protocol-based group
except when GVRP is expected to create the VLAN.
To remove the interface from this protocol-based VLAN group that is identified by this groupid, use
the no form of this command.
If you select all, all ports are removed from this protocol group.
Syntax
protocol vlan group groupid
no protocol vlan group groupid
• groupid—The protocol-based VLAN group ID, which is automatically generated when
you create a protocol-based VLAN group with the vlan protocol group command. To see
the group ID associated with the name of a protocol group, use the show port protocol all
command.
Default Configuration
This command has no default configuration.