Dell PowerEdge M805 - Manual (Page 651)

Loopback Interface Commands 655
Loopback Interface Commands
interface loopback
Use the interface loopback command in Global Configuration mode to enter the Interface
Loopback configuration mode.
Syntax
interface loopback loopback-id
no interface loopback loopback-id
• loopback-id—Loopback identifier. (Range: 0-7)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example enters the Interface Loopback 1 configuration mode.
console(config)# interface loopback 1
console(config-if-loopback1)#
show interfaces loopback
Use the show interfaces loopback command in Privileged EXEC mode to display information
about one or all configured loopback interfaces.