Dell PowerEdge M805 - Manual (Page 164)

130 Clock Commands
www
.dell.com | support.dell.com
• key-number — Authentication key to use when sending packets to this peer.
(Range: 1-4294967295)
• priority—Priority assigned to the server. (Range: 1-8)
Default Configuration
No servers are defined.
Command Mode
Global Configuration mode
User Guidelines
Up to 8 SNTP servers can be defined.
Use the sntp client enable command in Global Configuration mode to enable unicast clients
globally.
Polling time is determined by the sntp client poll timer <64-1024> global configuration
command.
Example
The following example configures the device to accept Simple Network Time Protocol
(SNTP) traffic from the server at IP address 192.1.1.1.
console(config)# sntp server 192.1.1.1
sntp trusted-key
Use the sntp trusted-key command in Global Configuration mode to authenticate the identity of a
system to which Simple Network Time Protocol (SNTP) will synchronize. To disable
authentication of the identity of the system, use the no form of this command.
Syntax
sntp trusted-key key-number
no sntp trusted-key key-number
• key-number — Key number of authentication key to be trusted. (Range: 1 - 4294967295)
Default Configuration
No keys are trusted.
Command Mode
Global Configuration mode