Dell PowerEdge M805 - Manual (Page 751)

OSPFv3 Commands 757
Retransmit Interval............................ 5
Hello Interval................................. 10
Dead Interval.................................. 40
LSA Ack Interval............................... 1
Iftransit Delay Interval....................... 1
Authentication Type............................ None
Metric Cost.................................... 1 (computed)
OSPF Mtu-ignore................................ Disable
OSPF cannot be initialized on this interface.
show ipv6 ospf range
Use the show ipv6 ospf range command in Privileged EXEC mode to display information about
the area ranges for the specified area identifier.
Syntax
show ipv6 ospf range areaid
• areaid—Identifies the OSPF area whose ranges are being displayed.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays information about the area ranges for area 1.
console#show ipv6 ospf range 1
Area ID IPv6 Prefix/Prefix Length Lsdb Type Advertisement
--------- ------------------------- --------------- -------------
show ipv6 ospf stub table
Use the show ipv6 ospf stub table command in Privileged EXEC mode to display the OSPF stub
table. The information below will only be displayed if OSPF is initialized on the switch.