Dell PowerEdge M805 - Manual (Page 272)

250 System Management Commands
www
.dell.com | support.dell.com
console(config-if)#ip address none
ip address
Use the ip address command to enable DHCP/BOOTP on the OOB port.
Syntax
ip address {dhcp/bootp}
Command Mode
Interface Configuration (out-of-band)
Default Configuration
This command has no default configuration.
User Guidelines
No specific guidelines.
Example
console(config)#interface out-of-band
console(config-if)#ip address dhcp
member
Use the member command in Stack Global Configuration mode to configure the switch. Execute
this command on the Management Switch. To remove a switch from the stack, use the no form of
the command.
Syntax
member unit switchindex
no member unit
• unit —The switch identifier of the switch to be added or removed from the stack. (Range:
1 - 12)
• switchindex—The index into the database of the supported switch types, indicating the
type of the switch being preconfigured. The switch index is a 32-bit integer.
Default configuration
This command has no defaults.