Tacacs+ commands, Telnet server commands, Vlan commands – Dell PowerEdge M805 User Manual
Page 66
28
Command Groups
www
.dell.com | support.dell.com
TACACS+ Commands
Telnet Server Commands
VLAN Commands
Command
Description
Mode*
key
Specifies the authentication and encryption key for all
TACACS communications between the device and the
TACACS server.
TC
port
Specifies a server port number.
TC
priority
Specifies the order in which servers are used.
TC
show tacacs
Displays TACACS+ server settings and statistics.
PE
tacacs-server host
Specifies a TACACS+ server host.
GC
tacacs-server key
Sets the authentication and encryption key for all
TACACS+ communications between the switch and the
TACACS+ daemon.
GC
tacacs-server timeout
Sets the interval for which the switch waits for a server host
to reply.
GC
timeout
Specifies the timeout value in seconds.
TC
*NOTE:
For the meaning of each Mode abbreviation, see Mode Types on page 4.
Command
Description
Mode*
ip telnet server disable
Enables/disables the Telnet service on the switch.
GC
ip telnet port
Configures the Telnet service port number on the switch.
GC
show ip telnet
Displays the status of the Telnet server and the Telnet
service port number.
PE
*NOTE:
For the meaning of each Mode abbreviation, see Mode Types on page 4.
Command
Description
Mode*
dvlan-tunnel ethertype
Configures the EtherType for the interface.
GC
interface vlan
Enters the interface configuration (VLAN) mode.
GC
interface range vlan
Enters the interface configuration mode to configure
multiple VLANs.
GC
mode dvlan-tunnel
Enables Double VLAN tunneling on the specified interface IC