Dell PowerEdge M805 - Manual (Page 72)

34 Command Groups
www
.dell.com | support.dell.com
DVMRP Commands
IGMP Commands
Command Description Mode*
ip dvmrp S ets the administrative mode of DVMRP in the router
to active.
GC
IC
ip dvmrp metric Configures the metric for an interface. IC
ip dvmrp trapflags Enables the DVMRP trap mode. GC
show ip dvmrp Displays the system-wide information for DVMRP. PE
show ip dvmrp interface Displays the interface information for DVMRP on the
specified interface. PE
show ip dvmrp neighbor Displays the neighbor information for DVMRP. PE
show ip dvmrp nexthop D isplays the next hop information on outgoing
interfaces for routing multicast datagrams.
PE
show ip dvmrp prune Displays the table that lists the router’s upstream prune
information. PE
show ip dvmrp route Displays the multicast routing information for DVMRP. PE
*NOTE: For the meaning of each Mode abbreviation, see Mode Types on page 4.
Command Description Mode*
ip igmp Sets the administrative mode of IGMP in the system to
active. GC
ip igmp last-member-query-count Sets the number of Group-Specific Queries sent before
the router assumes that there are no local members on the
interface. IC
ip igmp last-member-query-interval Configures the Maximum Response Time inserted in
Group-Specific Queries which are sent in response to
Leave Group messages.
IC
ip igmp query-interval Configures the query interval for the specified interface.
The query interval determines how fast IGMP Host-
Query packets are transmitted on this interface. IC
ip igmp query-max-response-time Configures the maximum response time interval for the
specified interface. IC
ip igmp robustness Configures the robustness that allows tuning of the
interface. IC