Classofservice ip-dscp-mapping – Dell PowerEdge M805 User Manual
Page 368
356
QoS Commands
www
.dell.com | support.dell.com
Syntax
classofservice dot1p-mapping 802.1ppriority trafficclass
no classofservice dot1p-mapping
•
802.1ppriority—Specifies the user priority mapped to the specified traffic class for this
switch. (Range: 0 - 7)
•
trafficclass—Specifies the traffic class for this switch. (Range: 0 - 6)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration or Interface Configuration (Ethernet, Port-channel) mode
User Guidelines
None
Example
The following example configures mapping for user priority 1 and traffic class 2.
console(config)#classofservice dot1p-mapping 1 2
classofservice ip-dscp-mapping
Use the classofservice ip-dscp-mapping command in Global Configuration mode to map an IP
DSCP value to an internal traffic class.
Syntax
classofservice ip-dscp-mapping ipdscp trafficclass
•
ipdscp—Specifies the IP DSCP value to which you map the specified traffic class.
(Range: 0 - 63)
•
trafficclass—Specifies the traffic class for this value mapping. (Range: 0 - 6)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.