Trapflags – Dell PowerEdge M805 User Manual
Page 754
Advertising
760
OSPFv3 Commands
www
.dell.com | support.dell.com
trapflags
Use the trapflags command in Router OSPFv3 Configuration mode to enable OSPF traps.
Syntax
trapflags
no trapflags
Default Configuration
Enabled is the default state.
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example enables OSPF traps.
console(config)#ipv6 router ospf
console(config-rtr)#trapflags
Advertising