Ip dvmrp trapflags – Dell PowerEdge M805 User Manual
Page 586
588
DVMRP Commands
www
.dell.com | support.dell.com
Syntax
ip dvmrp metric metric
no ip dvmrp metric
•
metric—Cost to reach the network. (Range: 1-31)
Default Configuration
1 the default value.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example configures a metric of 5 for VLAN 15.
console(config)#interface vlan 15
console(config-if-vlan15)#ip dvmrp metric 5
ip dvmrp trapflags
Use the ip dvmrp trapflags command in Global Configuration mode to enable the DVMRP trap
mode.
Syntax
ip dvmrp trapflags
no ip dvmrp trapflags
Default Configuration
Disabled is the default state.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following command enables DVMRP trap mode.