Dell PowerEdge M805 - Manual (Page 411)

Radius Commands 401
Global Values
--------------
TimeOut : 3
Retransmit : 3
Deadtime : 0
Source IP : 1.2.3.4
source-ip
Use the source-ip command in Radius mode to specify the source IP address to be used for
communication with Radius servers. 0.0.0.0 is interpreted as a request to use the IP address of the
outgoing IP interface.
Syntax
source-ip source
• source—A valid source IP address.
Default Configuration
The IP address is of the outgoing IP interface.
Command Mode
Radius mode
User Guidelines
User must enter the mode corresponding to a specific Radius server before executing this
command.
Example
The following example specifies 10.240.1.23 as the source IP address.
console(config)#radius-server host 192.143.120.123
console(config-radius)#source-ip 10.240.1.23
timeout
Use the timeout command in Radius mode to set the timeout value in seconds for the designated
Radius server.
Syntax
timeout timeout
• timeout—Timeout value in seconds for the specified server. (Range: 1-30 seconds.)