Dell PowerEdge M805 - Manual (Page 626)

630 IPv6 Routing Commands
www
.dell.com | support.dell.com
Syntax
clear ipv6 statistics [vlan vlan-id| tunnel tunnel-id | loopback loopback-id]
• vlan-id—Valid VLAN ID.
• tunnel-id—Tunnel identifier. (Range: 0-7)
• loopback-id—Loopback identifier. (Range: 0-7)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example clears IPv6 statistics for VLAN 11.
console(config)#clear ipv6 statistics vlan 11
ipv6 address
Use the ipv6 address command in Interface Configuration mode to configure an IPv6 address on
an interface (including tunnel and loopback interfaces) and to enable IPv6 processing on this
interface. Multiple globally reachable addresses can be assigned to an interface by using this
command. There is no need to assign a link-local address by using this command since one is
automatically created. IPv6 addresses can be expressed in eight blocks. Also of note is that instead
of a period, a colon separates each block. For simplification, leading zeros of each 16-bit block can
be omitted. One sequence of 16-bit blocks containing only zeros can be replaced with a double
colon "::", but not more than one at a time (otherwise it is no longer a unique representation).
Dropping zeros: 3ffe:ffff:100:f101:0:0:0:1 becomes 3ffe:ffff:100:f101::1
Local host: 0000:0000:0000:0000:0000:0000:0000:0001 becomes ::1
Any host: 0000:0000:0000:0000:0000:0000:0000:0000 becomes ::
The hexadecimal letters in the IPv6 addresses are not case-sensitive. An example of an IPv6 prefix
and prefix length is 3ffe:1::1234/64.
Syntax
ipv6 address prefix/prefix-length [eui64]
no ipv6 address [prefix/prefix-length] [eui64]
• prefix—Consists of the bits of the address to be configured.