Address table commands, Bridge address – Dell PowerEdge M805 User Manual
Page 143
Address Table Commands
109
Address Table Commands
bridge address
Use the bridge address command in Interface Configuration mode to add a static MAC-layer
station source address to the bridge table. To delete the MAC address, use the no form of the
bridge address command (using the no form of the command without specifying a MAC address
deletes all static MAC addresses belonging to this VLAN).
Syntax
bridge address mac-address {ethernet interface|port-channel port-channel-number}
[permanent|delete-on-reset|delete-on-timeout|secure]
no bridge address [mac-address]
•
mac-address—A valid MAC address in the format xxxx.xxxx.xxxx.
•
interface—A valid Ethernet port.
•
port-channel-number—A valid port-channel number.
•
permanent—The address can be deleted only by using the no bridge address command.
•
delete-on-reset—The address is deleted after reset.
•
delete-on-timeout—The address is deleted after "age out" time has expired.
•
secure—The address is deleted after the port changes mode to unlock learning (no port
security command). This parameter is only available when the port is in learning locked
mode.
Default Configuration
No static addresses are defined. The default mode for an added address is permanent.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.