Dell PowerEdge M805 - Manual (Page 189)

Ethernet Configuration Commands 157
show interfaces counters
Use the show interfaces counters command in User EXEC mode to display traffic seen by the
interface.
Syntax
show interfaces counters [ethernet interface | port-channel port-channel-number]
• interface—A valid Ethernet port.
• port-channel-number—A valid port-channel index.
Default Configuration
This command has no default configuration.
Command Modes
User EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays traffic seen by the physical interface:
console>show interfaces counters
Port InOctets InUcastPkts
---- ---------- ---------
1/g1 183892 1289
Field Description
Port The port number.
Port Type The port designated IEEE shorthand identifier. For example 1000Base-T refers
to 1000 Mbps baseband signaling including both Tx and Rx transmissions.
Duplex Displays the port Duplex status.
Speed Refers to the port speed.
Neg Describes the Auto-negotiation status.
MDIX Mode Displays the Auto-crossover status.
Admin State Displays whether the port is enabled or disabled.