Dell PowerEdge M805 - Manual (Page 347)

802.1x Commands 331
• discard-shutdown — Discard frames with source addresses that are not the supplicant
address, and shut down the port.
• trap seconds— Send SNMP traps and specifies the minimum time in seconds between
consecutive traps. (Range: 1- 1000000
)
Default Configuration
Discard frames with source addresses that are not the supplicant address. No traps.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command is relevant when Multiple Hosts is disabled and the user has been
authenticated successfully.
Example
The following example uses forward action to forward frames with source addresses that are
not the supplicant address.
console(config-if-1/g1)#dot1x single-host-violation forward trap
100
show dot1x advanced
Use the show dot1x advanced command in Privileged EXEC mode to display 802.1x advanced
features for the switch or for the specified interface.
Syntax
show dot1x advanced [ethernet interface]
• interface — Specifies a valid ethernet interface.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.