Dell PowerEdge M805 - Manual (Page 370)

358 QoS Commands
www
.dell.com | support.dell.com
conform-color
Use the conform-color command in Policy-Class-Map Configuration mode to specify second-level
matching for traffic flow, the only possible actions are drop, set-cos-transmit, setdscp-transmit, set-
prec-transmit, or transmit. In this two-rate form of the policy command, the conform action
defaults to send, the exceed action defaults to drop, and the violate action defaults to drop. These
actions can be set with this command.
Syntax
conform-color
Default Configuration
This command has no default configuration.
Command Mode
Policy-Class-Map Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example displays how to specify the conform-color command.
console(config-policy-classmap)#conform-color test_class
(test_class is <class-map-name>
cos-queue min-bandwidth
Use the cos-queue min-bandwidth command in either Global Configuration mode or Interface
Configuration mode to specify the minimum transmission bandwidth for each interface queue. To
restore the default for each queue’s minimum bandwidth value, use the no form of this command.
Syntax
cos-queue min-bandwidth bw-0 bw-1 … bw-n
no cos-queue min-bandwidth
• bw-0—Specifies the minimum transmission bandwidth for an interface. You can specify
as many bandwidths as there are interfaces (bw-0 through bw-n). (Range: 0 - 100 in
increments of 5)
Default Configuration
This command has no default configuration.