Dell PowerEdge M805 User Manual
Page 93
Using the CLI
55
Privileged EXEC Mode
Because many of the privileged commands set operating parameters, privileged access is password-
protected to prevent unauthorized use. The password is not displayed on the screen and is case
sensitive.
Privileged users enter into the Privileged EXEC mode from User EXEC mode, where the following
prompt is displayed.
Global Configuration Mode
Global Configuration commands apply to features that affect the system as a whole, rather than
just a specific interface. The Privileged EXEC mode command configure is used to enter the
Global Configuration mode.
Interface and Other Specific Configuration Modes
Interface configuration modes are used to modify specific interface operations. The following are
the Interface Configuration and other specific configuration modes:
•
MST—The Global Configuration mode command spanning-tree mst configuration is used
to enter into the Multiple Spanning Tree configuration mode.
•
Line Interface—Contains commands to configure the management connections. These
include commands such as line speed and timeout settings. The Global Configuration mode
command line is used to enter the Line Interface mode.
•
VLAN Database—Contains commands to create a VLAN as a whole. The Global
Configuration mode command vlan database is used to enter the VLAN Database mode.
•
Router OSPF Configuration – Global configuration mode command router ospf is used to
enter into the Router OSPF Configuration mode.
•
Router RIP Configuration – Global configuration mode command router rip is used to enter
into the Router RIP Configuration mode.
•
Router OSPFv3 Configuration – Global configuration mode command ipv6 router ospf is
used to enter into the Router OSPFv3 Configuration mode.
•
IPv6 DHCP Pool Mode– Global configuration mode command ipv6 dhcp pool is used to
enter into the IPv6 DHCP Pool mode.
•
Management Access List—Contains commands to define management access
administration lists. The Global Configuration mode command management access-list is
used to enter the Management Access List configuration mode.
console#
console(config)#