Yaskawa G7 Drive - Manual (Page 79)

3
-6
‹ Switching Modes
The mode selection display will appear when the MENU Key is pressed from a monitor or setting display.
Press the MENU Key from the mode selection display to switch between the modes.
Press the DATA/ENTER Key from the mode selection key to monitor data and from a monitor display to
access the setting display.
Fig 3.1 Mode Transitions
IMPORTANT
When running the Drive after using Digital Operator, press the MENU Key to select the drive mode (displayed
on the LCD screen) and then press the DATA/ENTER Key from the drive mode display to bring up the monitor
display. Run commands can't be received from any other display. (Monitor display in the drive mode will
appear when the power is turned ON.)
Frequency Ref
-DRIVE-
U1-02=60.00Hz
U1-03=10.05A
** Main Menu **
-DRIVE-
Operation
** Main Menu **
-QUICK-
Quick Setting
** Main Menu **
-ADV-
Programming
** Main Menu **
-VERIFY-
Modified Consts
** Main Menu **
-A.TUNE-
Auto-Tuning
Rdy
U1- 01 =60.00Hz
Monitor
-DRIVE-
U1-02=60.00Hz
U1-03=10.05A
Rdy
U1 - 01=60.00Hz
MENU
ESC
DATA
ENTER
Control Method
-QUICK-
A1-02=2
Initialization
-ADV-
A1 - 00=1
Select Language
None Modified
-VERIFY-
Reference Source
-DRIVE-
U1-02=60.00Hz
U1-03=10.05A
U1- 01 =60.00Hz
Frequency Ref
-DRIVE- Rdy
U1- 01= 0 60.00Hz
MENU
MENU
MENU
MENU
RESET
ESC
DATA
ENTER
ESC
ESC
DATA
ENTER
Control Method
-QUICK-
A1-02= 2
Open Loop Vector
DATA
ENTER
ESC
DATA
ENTER
ESC
DATA
ENTER
Select Language
-ADV-
A1- 00 =0 *1*
English
ESC
-ADV-
Select Language
English
ESC
DATA
ENTER RESET
DATA
ENTER
ESC
DATA
ENTER
ESC
DATA
ENTER DATA
ENTER
ESC
The constant number will be displayed if a
constant has been changed. Press the
DATA/ENTER Key to enable the change.
Monitor Display Setting Display
Mode Selection
Display
Display at Startup
Open Loop Vector
Tuning Mode Sel
-A.TUNE-
Standard Tuning
"0"
Tuning Mode Sel
-A.TUNE-
Standard Tuning
"0"
*2*
Rdy
A1- 00= 0 *1*
T1- 01 =0 1 *0* T1- 01= 0 *0*
*2*