Yaskawa G5HHP Drive - Manual (Page 179)

7.3 Flux Vector Control
7 - 15
7.3 Flux Vector Control
The functions that can be used with flux vector control are listed in Table 7.3. Details on functions that are specific
to flux vector control (i.e. those marked with a * ) are provided in the following table.
Table 7.3 Flux Vector Control Functions
Control
Method
Group Function Comments
V/
f
V/
fw
/P
G
Open
-loop
Ve
ctor
Fl
ux
Ve
ct
or
b1 Sequence Settings such as the reference input method f f f f
b2 DC Injection Braking DC injection braking function settings f f f f
b3 Speed Search Speed search function settings f f f f
b4 Delay Timers Timer function settings f f f f
b Application b5 PID Control PID control settings f f f f b Application
b6 Dwell Functions Hold Acceleration/deceleration time dwell function settings f f f f
b7 Droop Control * Droop Control function settings x x x
f
b8 Energy Saving Not used. (Can’t be set.) f f
x x
b9 Zero Servo * Zero-servo function settings x x x f
C1 Accel/Decel Acceleration/deceleration time settings f f f f
C2 S-Curve Acc/Dec S-curve characteristics for accel/decel times f f f f
C3 Motor-Slip Compensation * Motor temperature compensation function adjustment f f f f
C Tuning
C4 Torque Compensation Not used. (Can’t be set.) f f f
x
C Tuning
C5 Speed Controls Speed control loop adjustment x
f
x
f
C6 Carrier Frequency Carrier frequency settings f f f f
C7 Hunting Prevention Not used. (Can’t be set.) f f
x x
C8 Factory Tuning Not used. (Can’t be set.) x x
f
x
d1 Preset Reference Frequency reference settings (when using Operator) f f f f
d2 Reference Limits Frequency upper and lower limit settings f f f f
d Reference
d3 Jump Frequencies Prohibited frequency settings f f f f
d Reference
d4
Reference frequency hold
function
Up/Down, Accel/Decel stop hold frequency setting f f f f
d5 Torque Control * Torque control settings and adjustment x x x f
E1 V/f Pattern
* Motor constant settings
f f f f
E2 Motor Setup
* Motor constant settings
(Motor constants set automatically with autotuning.) f f f f
E Motor E3 Motor 2 Control Methods Control method settings for motor 2. f f f f
E4 Motor 2 V/f Characteristics V/f characteristics settings for motor 2. f f f f
E5 Motor 2 Motor Constants Motor constant settings for motor 2. f f f f
F1
PG Speed Control Card
Settings
Constant settings for a PG Speed Control Card x
f
x
f
F2 Analog Reference Card AI User constant settings for an Analog Reference Card f f f f
F3 Digital Reference Card DI User constant settings for a Digital Reference Card f f f f
F4 Analog Monitor Card AO User constant settings for an Analog Monitor Card f f f f
F Options
F5 Digital Output Card DO User constant settings for a Digital Output Card f f f f
F Options
F6 Digital Output Card DO User constant settings for a Digital Output Card f f f f
F7 Pulse Monitor Card PO User constant settings for a Pulse Monitor Card f f f f
F8
SI-F/SI-G Transmission
Card
User constant settings for a Transmission Card f f f f
F9
CP-916B Transmission
Card
User constant settings for a Transmission Card f f f f
7