Yaskawa G5HHP Drive - Manual (Page 88)

Setting User Constants
4.2.4 Operation Mode
4 - 20
Changing Monitor Display to Output Current at Startup in Basic Access Level
Use the following procedure to change user constant o1-02 so that the output current is displayed at startup.
(The procedure continues from the end of the previous example.)
Step Key Sequence Digital Operator Display Remarks
1  User Monitor Sel
Output kWatts
Check the display.
2 Power-On Monitor
Frequency Ref
3
DATA
ENTER
o1--02 = 1 ***
Frequency Ref
4
Press twice.
o1--02 = 3
Output Current
5
DATA
ENTER Entry Accepted
Writes-in the new setting.
Power-On Monitor
Output Current
After a few seconds, the Operator dis-
play is as shown on the left.
6
ESC
Function o1
Monitor Select
7
ESC
G5 * Main Menu *
Programming
Output current has been set in monitor selection after power ON.
4
A EXAMPLE "