Yaskawa G5HHP Drive - Manual (Page 60)

Wiring
3.7.3 Wiring a PG Speed Control Card
3 - 20
J
PG-D2 (For V/f with PG Feedback Mode Only)
PG
Power supply +12 V
Power supply 0 V
Pulse monitor output
Pulse input -- (A/B phase)
Power supply +5 V
Pulse input + (A/B phase)
Three-phase, 400 VAC
(575 VAC)
VS-616G5
4CN
E
R/L1
S/L2
T/L3
U/T1
V/T2
W/T3
IM
PG-D2
4CN
TA1
E
TA2 (E)
1
2
3
4
5
6
7
8
D Shielded twisted-pair wires must be used for signal lines.
D Do not use the pulse generator’s power supply for anything other than the pulse
generator (encoder). Using it for another purpose can cause malfunctions due
to noise.
D The length of the pulse generator’s wiring must not be more than 100 meters.
Fig 3.14 PG-D2 Wiring
3