Yaskawa G5HHP Drive - Manual (Page 99)

4.2 Modes
4 - 31
Group
Control
Method
Comments Display Function Group
Fl
ux
Ve
ct
or
Open
-loop
Vector
V/
fw
/P
G
V/
f
Comments Display Function
F1
PG speed control card
settings
PG Option Setup User constant settings for a PG Card X f X f
F2
Analog Reference Card
AI
AI-14 Setup
User constant settings for an Analog Ref-
erence Card f f f f
F3 Digital Reference Card DI DI-08, 16 Setup
User constant settings for a Digital Refer-
ence Card f f f f
F4 Analog Monitor Card AO AO-08, 12 Setup
User constant settings for an Analog
Monitor Card f f f f
F Options F5 Digital Output Card DO DO-02C
User constant settings for a Digital Out-
put Card
f f f f
F6 Digital Output Card DO DO-08
User constant settings for a Digital Out-
put Card f f f f
F7 Pulse Monitor Card PO PO-36F Setup
User constant settings for a Pulse Monitor
Card f f f f
F8
SI-F/SI-G Transmission
Card
SI-F/G
User constant settings for a Transmission
Card f f f f
F9
CP-916B Transmission
Card
DDS/SI-B
User constant settings for a Transmission
Card f f f f
H1 Multi-function inputs Digital Inputs
Function selection for multi-function in-
puts
f f f f
H2 Multi-function outputs Digital Outputs
Function selection for multi-function out-
puts f f f f
H Terminal H3 Analog inputs Analog Inputs Function selection for analog inputs f f f f
H4
Multi-function analog out-
puts
Analog Outputs Function selection for analog outputs f f f f
H5
MEMOBUS communica-
tions
Serial Com Setup MEMOBUS communications settings f f f f
L1 Motor protection functions Motor Overload Overload protection settings and selection f f f f
L2
Momentary power loss
ride-through
PwrLoss Ridethru
Selects the power-loss processing meth-
od. f f f f
L3 Stall prevention Stall Prevention Stall prevention settings and selection f f f f
L Protection
L4 Frequency detection Ref Detection
Frequency detection settings and selec-
tion
f f f f
L Protection
L5 Fault restart Fault Restart Fault restart function settings f f f f
L6 Overtorque detection Torque Detection
Overtorque detection settings and selec-
tion f f f f
L7 Torque limits Torque Limit Torque limit settings (vector control only) X X f f
L8 Hardware protection Hdwe Protection
Overheating and phase loss protection
settings f f f f
o1 Display/Monitor settings Monitor Select Selects the display and setting methods. f f f f
o Operator
o2 Function settings Key Selections
Key function selection and other user
constants f f f f
Figure 4.11 shows the difference in the display structure for the various access levels.
4