Yaskawa G5HHP Drive - Manual (Page 96)

Setting User Constants
4.2.5 Initialize Mode
4 - 28
D
The following restrictions apply to setting/displaying user constants when the access level is set to the
user program access level.
Operation The Quick-start level user constants can be displayed.
Initialize The Quick-start level user constants can be displayed or set.
Programming Only the user constants specified in A2-01 through A2-32 can be displayed or
set.
Autotuning The user constants cannot be displayed.
Modified constants The user constants cannot be displayed.
Setting C1-08 (Deceleration Time 4) in A2-01 to Define it as a User Constant
Step Key Sequence Digital Operator Display Remarks
1
MENU
G5* Main Menu *
Operation
2
G5* Main Menu *
Initialize
3
DATA
ENTER
Select Language
English
4 Function A2
User Constants
5
DATA
ENTER
User Param 1
A2--01 = ----------
6
DATA
ENTER
User Param 1
--------------
The first digit blinks.
7
Press twice.
User Param 1
C1--01
8
Press twice.
RESET
User Param 1
C1--01
Writes-in set value 0000.
9
Press 7 times.
User Param 1
C1--08
10
DATA
ENTER Entry Accepted
Writes-in the new setting.
User Param 1
A2--01 = C1--08
After a few seconds, the Operator dis-
play is as shown on the left.
11
ESC
Function A2
User Constants
12
Press twice.
Access Level
Advanced
13
DATA
ENTER
A1--01 = 4***
Advanced
14
Press twice.
A1--01 = 1
User Program
The user program access level can be
set only after one or more constants are
set as user constants in A2-01 to A2-32.
If no constants are set, the user program
access level will not be displayed for
A1-01.
4
A
EXAMPLE
"