Yaskawa G5HHP Drive - Manual (Page 61)

3.7 Installing and Wiring PG Speed Control Cards
3 - 21
J
PG-X2 (For Flux Vector Control Mode Only)
IM
PG-X2
4CN
Power supply +12 V
Power supply 0 V
B-phase pulse monitor output
TA2
E
TA3 (E)
1 TA1
A-phase pulse monitor output
A-phase pulse input (--)
A-phase pulse input (+)
B-phase pulse input (--)
Z-phase pulse monitor output
9
10
B-phase pulse input (+)
Power supply +5 V
Three-phase, 400 VAC
(575 VAC)
4CN
E
R/L1
S/L2
T/L3
U/T1
V/T2
W/T3
VS-616G5
2
3
4
5
6
7
8
1
2
3
4
5
6
7
D Shielded, twisted-pair wire must be used for signal lines.
D Do not use the pulse generator’s power supply for anything other than the
pulse generator (encoder). Using it for another purpose can cause
malfunctions due to noise.
D The length of the pulse generator’s wiring must not be more than 100 meters.
D The direction of rotation of the PC can be set in user constant F1-05. The
factory preset if for forward rotation, A-phase advancement.
PG
Fig 3.15 PG-X2 Wiring
3