Yaskawa G5HHP Drive - Manual (Page 337)

10.1 Maintenance and Inspection
10 - 13
1. Adjust the rack height using the up/down handle of the Module draw-out lift.
AC
L
Lift Inverter Panel
(1292)
700
2300
Module
Rack
Fixing pin
Sliding table
Up/down handle
Stopper
Fig 10.14 Special Lift
2. Insert the sliding table between the Panel beam and the module mounting base.
Module
Module Mounting Base
Beam
Sliding table
Fig 10.15 Sliding Table Insertion
3. Hook the lifter stopper and, while pressing the sliding table so that it will not move when the Module is
pulled out, draw out the Module.
4. Insert the fixing pin into the module holder to keep the Module stationary and then lower the rack.
J
Mounting the Module
Mount the Module by reversing the above module dismounting and drawing out procedure.
10