Sony GP-X1EM Grip Extension - Manual (Page 318)

318
Time Settings
You can determine the execution time of an effect by
setting either the keyframe durations or the effect duration
(see page 299) .
You can make execution time settings in the utility/
shotbox control block.
Setting the Keyframe Duration
Utility/shotbox control block
1
Press the [KF MCRO EDIT] button, then press the
[EDIT ENBL] button, turning it on orange.
2
Stop the effect on the keyframe for which you want to
set the duration.
The time from this keyframe to the following
keyframe is what you set.
3
Press the [KF DUR] button.
The display in the numeric keypad control block
shows “KF DUR” followed by the duration of the
current keyframe (seconds:frames).
4
Using the numeric keypad in the numeric keypad
control block, enter the timecode value, as a maximum
of four digits.
For example, to set 9 seconds and 20 frames, enter
920.
You can also use the [TRIM] button to enter a
difference value
(see page 310) .
5
Press the [ENTER] button to confirm the entry.
The keyframe duration may also be automatically
changed as a result of changing the effect duration.
For details, see “Time Settings” (page 299).
Setting the Effect Duration
1
Press the [KF MCRO EDIT] button, then press the
[EDIT ENBL] button, turning it on orange.
2
Press the [EFF DUR] button.
The display in the numeric keypad control block
shows “DUR” followed by the effect duration
(minutes:seconds:frames).
3
Using the numeric keypad in the numeric keypad
control block, enter the timecode value, as a maximum
of six digits.
For example, to set 3 minutes 7 seconds and 15 frames,
enter 30715.
You can also use the [TRIM] button to enter a
difference value
(see page 310) .
4
Press the [ENTER] button to confirm the entry.
The effect duration may also be changed by inserting
or deleting keyframes.
For details, see “Time Settings” (page 299).
Delay Setting
1
Press the [KF MCRO EDIT] button, then press the
[EDIT ENBL] button, turning it on orange.
2
Press the [DELAY] button.
The display in the numeric keypad control block
shows “DELAY” followed by the delay time
(seconds:frames).
3
Using the numeric keypad in the numeric keypad
control block, enter the timecode value, as a maximum
of four digits.
KF DUR button
EFF DUR button
KF MCRO EDIT button
EDIT ENBL button DELAY button
Note
Note