Sony GP-X1EM Grip Extension - Manual (Page 389)

Chapter
17
389
System Setup
About system setup
This configures the setup for the whole system.
Here, the “whole system” refers to all devices connected
on the switcher system LAN.
Unit ID settings
When there are two switchers on the same network, the
unit IDs are set as follows.
The unit IDs for DMEs are automatically assigned as
follows.
Menu panel unit IDs are set in the Engineering Setup
>System >Network Config menu (7311)
(see page 389) .
For details about unit IDs of devices other than the menu
panel, refer to the installation manual for each device.
Settings Relating to the
Network
This section describes the configuration of devices
connected to the switcher system LAN.
Setting the Group ID and Unit ID of
the Menu Panel
1
In the Engineering Setup >System >Network Config
menu (7311), press [Group ID].
2
Enter the group ID number (1 to 8) using the numeric
keypad, then press [Enter].
3
Perform the following operations.
To set the group ID only: Check the message, then
press [Yes] to exit the settings.
To set the unit ID: Check the message, then press
[No] and skip to step 4 .
4
Press [Unit ID].
5
Enter the unit ID number (1 to 4) using the numeric
keypad, then press [Enter].
6
Check the message, then press [Yes].
Configuring the NFS Server
Set the address of the NFS server to use.
1
In the Engineering Setup >System >Network Config
menu (7311), press [NFS Server].
2
Enter the server address using the keyboard window,
then press [Enter].
Switcher Unit ID
1st switcher 1
2nd switcher 2
DME Unit ID
DME of 1st switcher (Ch1 to Ch4) 1
DME of 2nd switcher (Ch1 to Ch4) 3