Flexi pad control block – Sony GP-X1EM Grip Extension User Manual
Page 34
34
a
Independent key transition display section
The following information is displayed for the assigned
key on the [KEY ON] buttons.
• Key material name (key source name when a key source
is selected on the key bus of the cross-point control
block)
• DME channel or resizer being used
• Transition rate
• Transition type
b
KEY ON buttons
Inserts or removes the key assigned to the button
instantaneously.
If a key is currently inserted, the corresponding key button
is lit.
You can assign a key (KEY1 to KEY8) of any switcher
bank (M/E-1 to M/E-5, PGM/PST) to the [KEY ON]
buttons in the Setup menu.
For details, see “Setting Independent Key Transition
Control Block Button Assignments” (page 412).
c
AUTO TRANS (auto transition) buttons
Inserts or removes the key assigned to the [KEY ON]
button with the set transition rate and transition type
automatically.
During the execution of the transition, the button is lit.
Flexi Pad Control Block
You use the Flexi Pad control block for recalling and
saving snapshots, wipe snapshots, DME wipe snapshots,
and key snapshots, for recalling and creating macros, for
recalling and executing shotboxes and master timelines,
for entering the transition rate, and for other tasks.
c
AUTO
TRANS
buttons
a
Independent key transition display section
b
KEY ON buttons
b
KEY ON
buttons
c
UNDO button/
DEL button
a
Mode selection buttons
b
Memory recall section
d
Bank selection
buttons