Sony GP-X1EM Grip Extension - Manual (Page 356)

356
This switches the memory recall section to macro
operation mode.
The last recalled bank is displayed.
2
Use the bank selection buttons to select the target bank
for operation.
Select from bank 0 to 99 (register number 1 to 999).
For details about bank selection, see “Bank and
register selection in the Flexi Pad control block”
(page 333).
3
Press the button for the target register.
The macro register is recalled, and the macro is
executed. During macro execution, the selected button
blinks orange.
The selected bank and register number are displayed
on the top right button in the memory recall section,
and the number of executed events and total number of
events are displayed on the center button in the bottom
row.
• Multi mode (see page 349) is disabled if a macro register
is recalled using the Flexi Pad control block. Only one
macro can be executed at a time.
• If the same macro is recalled during macro execution or
when the macro is paused, the following operation
depends on a setting in the Setup menu.
For details, see “Setting the Macro Operation Mode”
(page 434).
• Events registered in a macro are executed according to
the setup and the device configuration in force when the
events were registered. If the state has changed since
registration, the contents of the macro may not be
reproduced correctly when the macro is recalled.
• During macro execution, if you switch the control panel
to macro editing mode, the macro currently being
executed stops.
• It is not possible to execute a macro during macro
editing.
• While executing a macro, the operation performed if
another macro is recalled from the Flexi Pad control
block depends on a setting in the Setup menu.
For details, see “Setting the Macro Operation Mode”
(page 434).
When a pause event is configured
When execution of a macro is paused, the [TAKE] button
is displayed in the memory recall section.
Press the [TAKE] button to resume the macro.
Executing a macro in step execution mode
1
Recall a macro register using steps 1 to 3 in
“Executing a macro in normal execution mode”
(page 355)
.
The selected bank and register number are displayed
on the top right button in the memory recall section,
and the number of executed events and total number of
events are displayed on the center button in the bottom
row.
2
Press the [TAKE] button in the memory recall section.
This executes one event registered in the macro, then
stops.
3
Repeat step 2 , executing the macro event by event.
Macro Creation and Editing
Setting auto insert mode
To enable auto insert mode, press the [AUTO INS] button
in the memory recall section, turning it on orange.
When you start to create or edit a macro with the macro
execution mode set to normal execution mode, auto insert
mode is automatically enabled.
To set auto pause insert mode
To enable auto pause insert mode, press and hold the
[AUTO INS] button. The button indication changes to
[AUTO PAUSE] button, and turns on blue.
To disable auto pause insert mode, press and hold the
[AUTO PAUSE] button or exit macro creation/editing.
For details about auto insert mode, see “Auto insert
mode” (page 349).
Creating a macro
1
In the Flexi Pad control block, press the [MCRO]
button.
This switches the memory recall section to macro
operation mode.
The last recalled bank is displayed.
2
Use the bank selection buttons to select the target bank
for operation.
Select from bank 0 to 99 (register number 1 to 999).
For details about bank selection, see “Bank and
register selection in the Flexi Pad control block”
(page 333).
Notes