Dell POWEREDGE M1000E - Manual (Page 169)

Fabric OS Message Reference 147
53-1002749-01
AUTH-1011
5
AUTH-1011
Message Failed to register for failover operation: switch <switch number> error <error
code>.
Message Type LOG
Severity WARNING
Probable Cause Indicates an internal problem with the Secure Fabric OS.
Recommended
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
AUTH-1012
Message Authentication <code> is rejected: port <port number> explain <explain code>
reason <reason code>.
Message Type LOG
Severity WARNING
Probable Cause Indicates that the specified authentication is rejected because the remote entity does not support
authentication.
Recommended
Action
Verify the hash type, protocol, group, and authentication policy using the authutil --show command.
AUTH-1013
Message Cannot perform authentication request message: port <port number>, message code
<message code>.
Message Type LOG
Severity WARNING
Probable Cause Indicates that the system is running low on resources when receiving an authentication request. Usually
this problem is transient. The authentication may fail.
Recommended
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.