Dell POWEREDGE M1000E - Manual (Page 223)

Fabric OS Message Reference 201
53-1002749-01
C3-1026
5
C3-1026
Message S<slot number>,P<port number>(<blade port number>): Faulting F_port due to extra
credit detected:ftx=<ftx> curr_cred=<current credits> actual_cred=<actual
credits>.
Message Type LOG
Severity WARNING
Probable Cause Indicates that the device is returning the wrong number of receiver-ready (R_RDY) frames.
Recommended
Action
When this error is observed persistently, replace the device.
C3-1027
Message Detected credit loss on Peer internal Port of Slot <slot number>, Port <port
number>(<blade port number>) vc_no=<vc number> crd(s)lost=<Credit(s) lost>
complete_loss:<complete credit loss>.
Message Type LOG
Severity INFO
Probable Cause Indicates that credit loss was detected on the peer port.
Recommended
Action
When this error is observed persistently, power cycle the specified blade using the slotPowerOff and
slotPowerOn commands. If the problem persists, replace the blade.
C3-1028
Message Detected excessive Link resets on the port in a second. Slot <slot number>, Port
<port number>(<blade port number>).
Message Type LOG
Severity WARNING
Probable Cause Indicates that the port received excessive link resets from peer port within 1 second and that exceeded
the threshold.
Recommended
Action
When this error is observed persistently, change the small form-factor pluggable (SFP) transceiver or the
cable on the peer port to which this port is connected.