Dell POWEREDGE M1000E - Manual (Page 924)

902 Fabric OS Message Reference
53-1002749-01
ZONE-1054
5
ZONE-1054
Message Default Zone All Access mode is set with Frame Redirection zones.
Message Type LOG
Severity WARNING
Probable Cause Indicates that the Default Zone All Access mode will not grant all access behavior when the frame
redirection zones are defined.
Recommended
Action
Remove frame redirection zones or set the Default Zone access mode to No Access using the defzone
--noaccess command.
ZONE-1057
Message TI Zone <TI zone name> has domain <Domain ID of switch with version pre6.4.0>
running pre FOS6.4.0 firmware. TI member (Domain <Domain ID of higher port index>,
Index <Higher port index>) is not supported.
Message Type LOG
Severity WARNING
Probable Cause Indicates that an unsupported port index (> 511) is present in the TI zone path or the routing may not be
set up correctly.
Recommended
Action
Remove the port index from the TI zone using the zone --remove name command.
ZONE-1058
Message
Domain <Domain ID of the switch that becomes unreachable> present in TI zone <TI
zone name> became unreachable due to failover disabled mode.
Message Type LOG
Severity WARNING
Probable Cause Indicates that the domain present in the TI zone path is unreachable. This occurs if the TI zone paths are
unavailable or the TI zone is set up incorrectly.
Recommended
Action
Verify that the paths defined by TI zones are online or remove the domain from the TI zone using the
zone --delete name command.