Dell POWEREDGE M1000E - Manual (Page 881)

Fabric OS Message Reference 859
53-1002749-01
TRCE-1004
5
Recommended
Action
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
TRCE-1004
Message Trace dump<slot on which the trace dump occurs> was not transferred because trace
auto-FTP disabled.
Message Type LOG
Severity WARNING
Probable Cause Indicates that trace dump files have been created on the switch or the specified slot, but the trace dump
files were not automatically transferred from the switch because auto-FTP is disabled.
Recommended
Action
Execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the
supportSave command and contact your switch service provider.
TRCE-1005
Message FTP Connectivity Test failed due to error.
Message Type LOG
Severity ERROR
Probable Cause Indicates that the connectivity test to the FTP host failed because of reasons such as a wrong FTP
address, FTP site is down, network is down, and so on.
Recommended
Action
Execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the
supportSave command and contact your switch service provider.
TRCE-1006
Message FTP Connectivity Test succeeded to FTP site ' <FTP target configured by users> '.
Message Type LOG
Severity INFO
Probable Cause Indicates that a connectivity test to the FTP host has succeeded. This feature is enabled using the
supportftp -t command.
Recommended
Action
No action is required.