Dell POWEREDGE M1000E - Manual (Page 36)

14 Fabric OS Message Reference
53-1002749-01
Displaying message content on switch
1
Displaying message content on switch
Beginning with Fabric OS v7.1.0, you can view the message documentation such as the message
text, message type, class (for audit messages), message severity, cause, and action on the switch
console by using the rasMan message_ID command.
To display the message documentation on switch, perform the following steps.
1. Log in to the switch as admin.
2. Use the rasMan message_ID command to display the documentation of a message. The
message_ID values are case-sensitive.
portLogResize Resizes the port log to the specified number of entries.
portLogShow Displays the port log, with page breaks.
portLogShowPort Displays the port log of the specified port, with page breaks.
portLogTypeDisable Disables an event from reporting to the port log. Port log events are described by the
portLogEventShow command.
portLogTypeEnable Enables an event to report to the port log. Port log events are described by the
portLogEventShow command.
rasAdmin Used to enable or disable logging for selected messages or modules, to change the
default severity level for a specified message, and to display configured RASLog
message settings.
rasMan Displays message documentation on switch.
setVerbose Sets the verbose level of a particular module within the Fabric OS.
snmpConfig Manages the SNMP agent configuration.
supportFfdc Enables and disables FFDC.
supportFtp Sets, clears, or displays support FTP parameters or a time interval to check the FTP
server.
supportSave Collects RASLog, trace files, and supportShow (active CP only) information for the local
CP and then transfers the files to an FTP server. The operation can take several
minutes.
supportShow Executes a list of diagnostic and error display commands. This output is used by your
switch service provider to diagnose and correct problems with the switch. The output
from this command is very long.
syslogdFacility Changes the syslogd facility.
syslogdIpAdd Adds an IP address as a recipient of system messages.
syslogdIpRemove Removes an IP address as a recipient of system messages.
syslogdIpShow Views the currently configured IP addresses that are recipients of system messages.
traceDump Displays, initiates, or removes a Fabric OS module trace dump.
TABLE 3 Commands for viewing or configuring the system parameters and message logs (Continued)
Command Description