Dell POWEREDGE M1000E - Manual (Page 849)

Fabric OS Message Reference 827
53-1002749-01
SULB-1007
5
SULB-1007
Message Standby CP reboots.
Message Type LOG
Severity INFO
Probable Cause Indicates that the standby control processor (CP) is rebooting with new firmware.
Recommended
Action
No action is required. The firmwareDownload command is progressing as expected.
Run the firmwareDownloadStatus command for more information.
SULB-1008
Message Standby CP booted successfully with new firmware.
Message Type LOG
Severity INFO
Probable Cause Indicates that the standby control processor (CP) has rebooted successfully.
Recommended
Action
No action is required. The firmwareDownload command is progressing as expected.
Run the firmwareDownloadStatus command for more information.
SULB-1009
Message Firmwaredownload command failed. Status: 0x<status code>, error: 0x<error code>.
Message Type AUDIT | LOG
Class FIRMWARE
Severity INFO
Probable Cause Indicates that the firmwareDownload command failed. The additional status code and error code values
provide debugging information.
The following table lists firmwareDownload status messages and status codes. Some of them will
not be displayed in this RASLog message and are listed for completeness.
TABLE 7 Status messages and status codes
Status message Status code
"Firmware download sanity check failed." 0x30
"Sanity check failed because system is non-redundant." 0x31
"Sanity check failed because firmware download is already in progress." 0x32
"Sanity check failed because Fabric OS is disabled on active CP." 0x33