Dell POWEREDGE M1000E - Manual (Page 315)

Fabric OS Message Reference 293
53-1002749-01
EM-1064
5
EM-1064
Message Blade:<Slot Id> is being powered off (based on user configuration) upon receiving
a HW ASIC ERROR, reason:<Fault reason>.
Message Type LOG
Severity CRITICAL
Probable Cause Indicates that the blade is being powered off because a hardware (HW) application-specific integrated
circuit (ASIC) error was detected, and you have selected to power off the problem blade when such a
condition occurred.
Recommended
Action
Contact your switch service provider for assistance.
EM-1065
Message
SAS Virtualization Services are not available due to incompatibility between the
FOS and SAS versions<Slot number or blank for single board systems>.
Message Type LOG
Severity WARNING
Probable Cause Indicates that the version of the control processor firmware (CFOS) or the blade processor firmware
(BFOS) is not compatible with the Storage Application Services (SAS) or other application firmware
versions.
Recommended
Action
Upgrade the Fabric OS firmware or the SAS firmware by using the firmwareDownload command. Refer
to the release notes for a compatible version of firmware.
EM-1066
Message SAS Virtualization Services are now available <Slot number or blank for single
board systems>.
Message Type LOG
Severity INFO
Probable Cause Indicates that the previously incompatible Fabric OS or Storage Application Services (SAS) firmware has
been upgraded and is now compatible.
Recommended
Action
No action is required.