Dell POWEREDGE M1000E - Manual (Page 743)

Fabric OS Message Reference 721
53-1002749-01
SEC-1135
5
Recommended
Action
Verify the security event was planned. If the security event was planned, no action is required. If the
security event was not planned, take appropriate action as defined by your enterprise security policy.
SEC-1135
Message Secure fabric version stamp has been reset.
Message Type LOG
Severity INFO
Probable Cause Indicates the version stamp of the secure fabric is reset.
Recommended
Action
Verify the security event was planned. If the security event was planned, no action is required. If the
security event was not planned, take appropriate action as defined by your enterprise security policy.
SEC-1136
Message
Failed to verify signature <data type, MUA, policy, etc.,>.
Message Type LOG
Severity ERROR
Probable Cause Indicates the receiving switch failed to validate the security database sent from the primary fabric
configuration server (FCS) switch. This message usually indicates that the data package is corrupted,
the time stamp on the package is out of range as a result of a replay attack or out-of-sync time service, or
the signature verification failed. Signature verification failure indicates either an internal error (such as
losing the primary public key) or an invalid database.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database may not be correctly updated for that switch.
This message may also be the result of an internal corruption or a hacker attack to the secure fabric.
SEC-1137
Message No signature in <data type, MUA, policy, etc.,>.
Message Type LOG
Severity ERROR
Probable Cause Indicates the receiving switch failed to validate the security database sent from the primary fabric
configuration server (FCS) switch. This message usually indicates that the data package is corrupted,
the time stamp on the package is out of range as a result of a replay attack or out-of-sync time service, or
the signature verification failed. Signature verification failure indicates either an internal error (such as
losing the primary public key) or an invalid database.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database may not be correctly updated for that switch.
This message may also be the result of an internal corruption or a hacker attack to the secure fabric.