Dell POWEREDGE M1000E - Manual (Page 344)

322 Fabric OS Message Reference
53-1002749-01
FABS-1005
5
FABS-1005
Message <Function name and description of problem> (<ID type>= <ID number>).
Message Type LOG
Severity WARNING
Probable Cause Indicates that an unsupported operation has been requested. This is usually an internal Fabric OS
problem or file corruption. The following is a possible value for function name and description of problem
variable:
fabsys_write: Unsupported write operation: process xxx
In this value, xxx is the process ID (PID), which could be any whole number.
Recommended
Action
Reboot or power cycle the active CP (for modular systems) or the switch (for single-board systems).
If the message persists, run the firmwareDownload command to update the firmware.
FABS-1006
Message
<Function name and description of problem>: object <object type id> unit <slot>.
Message Type LOG
Severity WARNING
Probable Cause Indicates that there is no device in the slot with the specified object type ID in the system module record.
This could indicate a serious Fabric OS data problem on the switch. The possible values for function
name and description of problem variable are:
• setSoftState: bad object
• setSoftState: invalid type or unit
• media_sync: Media oid mapping failed
• fabsys_media_i2c_op: Media oid mapping failed
• fabsys_media_i2c_op: obj is not media type
• media_class_hndlr: failed sending media state to blade driver
Recommended
Action
If the message is isolated, monitor the error messages on the switch. If the error is repetitive or if the
fabric failed, failover or reboot the switch.
If the message persists, run the firmwareDownload command to update the firmware.