Dell POWEREDGE M1000E - Manual (Page 213)

Fabric OS Message Reference 191
53-1002749-01
C2-1016
5
C2-1016
Message Port is faulted due to port re-initialization failure on internal Port S<slot
number>,P<port number>(<blade port number>) with reason <port fault reason>.
Message Type LOG
Severity ERROR
Probable Cause Indicates that the specified port failed due to port re-initialization failure.
Recommended
Action
When this error is observed persistently, power cycle the specified blade using the slotPowerOff and
slotPowerOn commands. If the problem persists, replace the blade.
C2-1017
Message Blade in Slot <slot number> failed due to unavailability of ports in the internal
trunk.
Message Type LOG
Severity ERROR
Probable Cause Indicates that the specified blade failed because of the unavailability of the ports in the internal trunk.
Recommended
Action
When this error is observed persistently, power cycle the specified blade using the slotPowerOff and
slotPowerOn commands. If the problem persists, replace the blade.
C2-1018
Message
Link reset threshold value exceeded in the link S<slot number>,P<port
number>(<blade port number>).
Message Type LOG
Severity ERROR
Probable Cause Indicates that the specified blade is faulted because the link reset threshold value has exceeded.
Recommended
Action
When this error is observed persistently, power cycle the specified blade using the slotPowerOff and
slotPowerOn commands. If the problem persists, replace the blade.