Dell POWEREDGE M1000E - Manual (Page 391)

Fabric OS Message Reference 369
53-1002749-01
FCR-1084
5
FCR-1084
Message The resume retry count is exhausted for the domain <Domain>.
Message Type LOG
Severity WARNING
Probable Cause Indicates that during the Coordinated HotCode protocol, a switch in the fabric did not accept the resume
message which prevented the protocol from completing. Any data traffic disruption observed during the
firmware download may have been the result of this issue.
Recommended
Action
No action is required.
FCR-1085
Message HA sync lost as remote CP does not support FCR based matrix.
Message Type LOG
Severity ERROR
Probable Cause Indicates that the remote control processor (CP) has older firmware, which does not support the
FCR-based matrix while the local CP has the feature enabled. This is causing the loss of the high
availability (HA) synchronization.
Recommended
Action
Disable the FCR-based matrix or upgrade the remote CP.
FCR-1086
Message HA sync lost as remote CP does not support 8 Gbps-capable FC based EX_Ports.
Message Type LOG
Severity ERROR
Probable Cause Indicates that the remote control processor (CP) has older firmware, which does not support 8
Gbps-capable FC based EX_Port. This is causing the loss of the high availability (HA) synchronization.
Recommended
Action
Disable 8 Gbps-capable FC based EX_Ports or upgrade the remote CP.