Dell POWEREDGE M1000E - Manual (Page 687)

Fabric OS Message Reference 665
53-1002749-01
PSWP-1004
5
PSWP-1004
Message Blade Swap complete for slots <slot number corresponding to the source blade> and
<slot number corresponding to the destination blade>.
Message Type LOG
Severity INFO
Probable Cause Indicates the bladeSwap command has been issued.
Recommended
Action
No action is required.
PSWP-1005
Message Blade Swap undo failed with error code <error code from undoBladeSwap>.
Message Type LOG
Severity WARNING
Probable Cause Indicates the bladeSwap command has not been undone.
Recommended
Action
Use the portSwapShow command to display a list of currently swapped ports; then use the portSwap
command to achieve the desired result.
PSWP-1006
Message Blade Swap failed on configInit with error code <error code from configInit> in
switch number <current switch number>.
Message Type LOG
Severity WARNING
Probable Cause Indicates the bladeSwap command failed on access to configuration data.
Recommended
Action
Retry the command. If the failure persists, contact your switch service provider.